PROGRAMMABLE DTM-2/433 REMOTE CONTROL
This 433.92 MHz DTM-2 remote control has been developed to drive automation, open and close garage doors, lock and unlock cigarrettes machines. You can install receivers in a multitude of equipment such as blinds, dangerous machines or lighting and activate them with these control. It has 2 or 4 channels or buttons, which are intended to be functional as compatible with receivers of the following brands: FACC, CELINSA, NICE, ROLLTORE, BFT, JCM, CLEMSA, CELINSA, V2, DEA SYSTEM, HORMANN, BELSON , CAME, CARDIN, GIBIDI, MATICDOOR, TELCOMA, VELLEMAN, PUJOL, ERREKA, FORSA, KAMAR, MX-ONDA, LIFT MASTER, GENIE and practically with 90% of fixed code commands on the market.
It must be programmed with our RF PLUS, RF DISPLAY TESTER, AITEC PROGRAMMER, FUTURE PLUS or FUTURE MIX devices.
To program our DTM-2 control with any of the mentioned brands, we will follow the following steps:
1.- Connect the three-pin connector to DTM-2 remote control as indicated in Fig. A.
2.- Having already placed on top of the duplicating machine, on the TEST AREA, the command to be copied, we will press on the DTM-2 the button in which we want to store the code; the light of this control will turn on and blinking, turning off after three flashes.
3.- Then we start transmitting with the original remote control on the machine until the light of the DTM-2 remote control flashes. It is recommended to do steps 2 and 3 as quickly as possible. If the original command had several buttons, we will repeat the entire process for each button, disconnecting and connecting the connector between each programming.