DTM-H6


DTM-H6

PROGRAMMABLE DTM-H6 Remote control. VARIABLE FREQUENCY

 

PRODUCT DESCRIPTION

 

This DTM-H6 remote control with frequency between 290 MHz and 440 MHz has been developed to drive automation, open and close garage doors, lock and unlock cigarrettes machines. You can install receivers in a multitude of equipment such as blinds, dangerous machines or lighting and activate them with this remote control. It has 2 or 4 channels, which are intended to be functional as compatible with receivers of the following brands: FACC, CELINSA, NICE, ROLLTORE, BFT, JCM, CLEMSA, CELINSA, V2, DEA SYSTEM, HORMANN, BELSON , CAME, CARDIN, GIBIDI, MATICDOOR, TELCOMA, VELLEMAN, PUJOL, ERREKA, FORSA, KAMAR, MX-ONDA, LIFT MASTER, GENIE and practically with 90% of fixed code brands on the market.

 

PROGRAMMING

eeee

It must be programmed with our RF PLUS, RF DISPLAY TESTER, AITEC PROGRAMMER, FUTURE PLUS or FUTURE MIX.

 

To program our DTM-H6 control with any of the mentioned brands, we will follow these steps:

 

1.- Connect the three-pin connector to DTM-H6 remote control as indicated in Fig. A.

2.- Having already placed on top of the duplicating machine, on the TEST AREA, the command to be copied, we will press on the DTM-H6, the button in which we want to store the code; the light of this control will turn on intermittently, turning off after three flashes.

3.- Then we start transmitting with the original remote control on the machine ( over test area) until the light of the destination control flashes. It is recommended to do steps 2 and 3 as quickly as possible. If the original command had several buttons, we will repeat the entire process for each button, disconnecting and connecting the connector between each programming.

4.- After duplicating the desired codes, it will be necessary to check which frequency transmits the original remote control and adjust that frequency in our DTM-H6. To do this we will place the DTM-H6 on the programming machine (Frequency meter) and turn the screw with a ceramic or plastic screwdriver until the frequency meter of the machine shows the same frequency that showed with the original control.

Accessories

Product Note Status Price
CERAMIC SCREWDRIVER CERAMIC SCREWDRIVER
One battery pack LR23A Energizer One battery pack LR23A Energizer
Five batteries pack LR23A Vinnic Five batteries pack LR23A Vinnic
Box of fifty batteries LR23A Vinnic Box of fifty batteries LR23A Vinnic
Display accessory details

Browse this category: Fixed Code Remote Controls